 SW-I002 1 1 1 0 update.tar.bz2.enc | SW-I002-1.1.1.0 - First full release versions of SW-I002 for EML1100 and EML1200. Check in system that Image is MB-I102-1.0.0 or above, if not contact skipper for new image. Download the file ( 80MB )and place it on a USB stick. Enter it into the CU-M101-SA display unit (EML1200 or EML1100) go to the diagnostics page. Enter the service level password, and activate 'Enable USB' . Press 'Refresh software and firmware versions' , and select the dpownloaded version Tee system will load in the software and reboot. It should keep the important settings (if the system image has not been updated in a separate process.) These are an encrypted packages (*.enc) Changes - improvements of stability - General Bug fixes - Numerous improvments | |
 Current Beta Versions | Folder with versions with changes. This version is a Beta version, The new features are tested, but Full test is not yet performed. The Regulations are still followed, however the new functions may not always perform as expected in some conditions, By using this you accept this, and will report to service@skipper.no any failures you experience. | |
| Old Versions | Older versions of SW-I002 for EML1100 and EML1200. These are an encrypted packages (*.enc) | |
| SW-I002 1 1 0 0 update.tar.bz2.enc | Software SW-I002-1.1.0.0 (19.09.2024) for EML1100 and EML1200, Limited release The following changes are made: User manual added in menu dropdown. Dimming is accessable even when no user This is an encrypted package (*.enc) To install place on a Clean USB disk, and insert in the Dispaly unit. Then run Software update from the diagnostics page. Div bug fixes and improvments. |